Phoenix, AZ

Completed an air conditioning repair for a residential customer. The air conditioner was not cooling their home effectively due to an evaporator coil that was clogged with dirt and debris. I removed the coil and cleaned it thoroughly, which resolved the issue. The customer was thankful for the service.

Repair on an old electric water heater.

Repair on a leaking water heater.

I sealed air ducts throughout a customer’s home today to improve cooling efficiency. I used mastic sealant and foil-backed tape to seal leaks and gaps in the ductwork, ensuring no air loss. I also installed zoned AC controls with Honeywell dampers, allowing the customer to control cooling in different areas of the home. After testing, the system is now more efficient and provides better temperature control.

I performed fall HVAC maintenance on a Lennox gas furnace today. I inspected the heat exchanger, cleaned the burner assembly, and replaced the air filter. I also tested the thermostat to ensure it was functioning properly and checked the blower motor for any wear. The system is ready for the colder months and is running efficiently.

I repaired an air conditioning system this morning that wasn’t cooling due to a clogged drain line. After clearing the drain line using a wet/dry vacuum, I added drain line tablets to prevent future clogs. I tested the system, and it is now draining properly and cooling the home effectively.

I installed a new AC system today, replacing an outdated unit with a Rheem Classic Series 14 SEER system. I connected the refrigerant lines, installed a new thermostat, and charged the system with R-410A refrigerant. After installation, I tested the system for proper cooling, and the new unit is functioning well, providing efficient cooling to the home.

I was called to repair a gas fireplace that was not working properly. I arrived at the house and found that the pilot light was out. I checked the gas line and found that it was not connected properly. I reconnected the gas line and tested the pilot light. The pilot light stayed lit, and the fireplace started working properly.

I was called to a home to diagnose a water heater that was leaking water. I arrived at the house and found that the water heater was leaking from the bottom. I inspected the water heater and found that the tank was cracked. I replaced the tank and refilled the water heater with fresh water. I also checked the pressure relief valve and made sure it was working properly. I tested the water heater to make sure it was working properly and that there were no leaks.

I was called to a home to check on a low-freon issue in an air conditioner. I performed a refrigerant leak search to find the leak and repaired it.

I replaced the condenser fan motor on a York air conditioner. It was a challenging job, but I was able to complete it successfully. I had to remove the old motor, install the new motor, and then test the system to ensure it was working properly.

I was called to repair an air conditioner that was not cooling. I arrived at the scene and found that the air conditioner was not cooling due to a faulty compressor. I diagnosed the problem and replaced the compressor, which resolved the issue.

Freon repair on an air conditioner coil.

Water heater replacement due to tank corrosion that caused a water leak.

Inspection of a water heater that is making popping noises.

Emergency water heater repair due to a major water leak.

Repair of a freon leak on a Goodman air conditioner.

Performed air duct cleaning on 2500 sq ft home. Used Viper Micro cleaning system with HEPA filtration. Cleaned all supply and return registers. Agitated and vacuumed main trunk lines. Fog-sanitized entire system with EnviroCON. Sealed duct seams with Mastic sealant. Improved system airflow by 22%.

I responded to an emergency AC repair call for a unit leaking refrigerant. Upon arrival, I located the source of the leak using a UV dye and detector kit. After identifying a small crack in the evaporator coil, I evacuated the remaining refrigerant and repaired the leak using a high-quality sealant. Once the repair was complete, I recharged the system with the appropriate amount of R-410A refrigerant, tested the unit for leaks, and ensured it was cooling effectively.

Repaired Frigidaire FAD704DWD dehumidifier. Diagnosed faulty compressor overload protector. Replaced with OEM part. Cleaned condenser coils, straightened fins. Replaced clogged air filter. Recharged system with R-134a. Calibrated humidistat. Tested amperage draw and dehumidification rate. Unit now functioning properly.

I responded to a service call for a gas fireplace that wouldn’t stay lit for more than a few minutes. After inspecting the unit, I found a faulty thermocouple, which was preventing the pilot light from staying on. I replaced the thermocouple with a new OEM part, ensuring proper alignment and connection to the gas valve. After reassembling the unit, I tested the fireplace, confirming it stayed lit consistently and operated safely, restoring full functionality to the system.

Addressed recurring drain issues on Goodman ARUF air handler. Installed EZ Trap overflow switch on primary drain. Added secondary drain line to exterior. Cleaned evaporator coil with Nu-Calgon Evap Foam No Rinse. Applied Pan-Spray enzymatic treatment to drain pan. Insulated drain lines to prevent condensation.

Replacing a 50 gallon water heater and installing a hot water recirculating pump so the client doesn't have to wait several minutes to get hot water at the master bedroom shower

I was called to repair a water heater that was leaking water. Upon inspection, I discovered that the leak was originating from a corroded temperature and pressure relief valve. After draining the tank to a safe level, I carefully removed the old valve and replaced it with a new, high-quality valve, ensuring a secure fit. Additionally, I checked all other connections for potential leaks and tightened them as needed. Once the repair was completed, I refilled the tank and tested the water heater to confirm there were no further leaks, restoring normal operation.

Arrived at a home to repair a gas fireplace that wouldn't stay lit. I inspected the fireplace and found that the gas valve was not opening. I replaced the valve and tested the fireplace, and it worked perfectly. The customer was thankful for the service.